Crosspoint 10100 Series, Specifications [JP]

Especificaciones

 
INTERFACES
WIRED ETHERNET Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data)
WIRELESS PROTOCOL – Radio #1: WORP® (Wireless Outdoor Router Protocol), – Radio #2: Wi-Fi (802.11b/g/n)
RADIO  
  Radio #1 Radio #2
FREQUENCY 4.900 – 5.925 GHz (Subject to Country Regulations) 2.400 – 2.484 (Subject to Country Regulations)
    802.11n 802.11g 802.11b
MIMO 2×2:2 2×2:2 N/A N/A
MODULATION OFDM
BPSK – QAM256
OFDM
BPSK – QAM64
OFDM
BPSK-QAM64
DSSS
DBPSK-CCK
DATA RATE Up to 866 Mbps Up to 300Mbps Up to 54Mbps Up to 11Mbps
  80 MHz 40 MHz 20 MHz 40 MHz 20 MHz 20 MHz 20 MHz
TX POWER (dual RF) MCS0: 28 MCS0: 28 MCS0: 29 MCS0/8: 26 MCS0/8: 26 6 Mbps: 26 1 Mbps: 26
MCS9: 21 MCS9: 22 MCS9: 25 MCS7/15: 20 MCS7/15: 21 54 Mbps: 22 11 Mbps: 26
RX SENSITIVITY (BER=10-6)  MCS0: -89 MCS0: -93 MCS0: -94 MCS0/8: -88/90 MCS0/8: -92/91 6 Mbps: -93 1 Mbps: -93
MCS9: -68 MCS9: -71 MCS8: -74 MCS7/15: -72/69 MCS7/15: -74/72 54 Mbps: -77 11 Mbps: -89
OTHER Dynamic Channel Selection (DCS) based on interference detection
Dynamic Frequency Selection (DFS) based on radar signature
Automatic Transmit Power Control (ATPC) with EIRP limit support
Automatic Channel Selection (ACS)
ANTENNA
  Radio #1 Radio #2
XP-10100-SUA Two N-type Connectors with built-in Surge Protection Two N-type Connectors with built-in Surge Protection
XP-10150-BS1/SUR Integrated 2×2 MIMO 22 dBi Dual Polarized 1 foot Antenna Two N-type Connectors with built-in Surge Protection
SECURITY
  Radio #1 Radio #2
ENCRYPTION AES 128 802.11i/WPA2 and WPA Wireless Security with AES-128, TKIP or WEP
AUTHENTICATION Internal MAC Address Control List, Radius based Authentication Enterprise/802.1x, Personal/ PSK (Pre Shared Key) or Open
802.1X SUPPORT   PEAP, LEAP, EAP-FAST, EAP-SIM, EAP-TTLS, EAP-AKA
QoS
  Radio #1 Radio #2
  Asymmetric UL/DL committed and maximum information rate per service flow with Best Effort and Real Time Polling Services 802.11e/WMM Enhanced Distributed Channel Access, 4 priority queues
Packet Classification Capabilities 802.1p priority, IPTOS, VLAN ID, IP addresses, ports, Ethernet addresses, IP protocol, and EtherType 802.1p priority, IPTOS
THROUGHPUT
  Radio #1 (RFC 2544) Radio #2
  Up to 672 Mbps @ 80 MHz Up to 150 Mbps
MANAGEMENT  
REMOTE Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3
SNMP SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
OTHER Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
Multi-Language Support Web Interface available in English, French, Spanish and Chinese
SYNCHRONIZATION
  Pass-trough SyncE and Precision Time Protocol (IEEE 1588v2) Ethernet Synchronization
NETWORK
MODES Radio #1 Radio #2
Bridging, Routing (RIP v2 and IP tunneling) Access Point
IP STACK IPv4 and IPv6 simultaneously
GATEWAY FEATURES DHCP Server & relay, NAT with Std ALGs
VLAN 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
POWER
INPUT OUTPUT
36 to 57 VDC via Ethernet port1 (PoE) 48 to 57 VDC – 25 Watt max on Ethernet port2 (PoE – software controlled)
12 VDC via Access port 12 VDC on Access port
Power should not be provided simultaneously on both ports.  
POWER CONSUMPTION
  16.5 Watt typical, 22.5 Watt maximum
ENVIRONMENTAL SPECS
TEMPERATURE OPERATING -40º to 60ºC (-40º to 140º Fahrenheit)
STORAGE -50º to 70ºC (-58º to 158º Fahrenheit)
HUMIDITY – IP RATING 100% relative humidity – IP67
WIND LOADING 200 km/h (125 mph)
PHYSICAL SPECS
    DIMENSIONS WEIGHT
PACKAGED XP-10100-SUA 14.56 x 13.0 x 7.87 in (370 x 331 x 200 mm) 10.91 lbs (4.95 kg)
XP-10150-BS1/SUR 14.56 x 13.0 x 7.87 in (370 x 331 x 200 mm) 11.90 lbs (5.4 kg)
UNPACKAGED XP-10100-SUA 9.84 x 8.66  x 2.83 in (250 x 220 x 72 mm) 5.07 lbs (2.3 kg)
XP-10150-BS1/SUR 12 x 12 x 3.40 in (305 x 305 x 85 mm) 6.17 lbs (2.8 kg)
SAFETY STANDARDS
  IEC 62368-1:2016 & 60950-22:2016
UL 62368-1 2nd edition & 60950-22 2nd edition
CAN/CSA C22.2 No 62368-1:14 & No 60950-22:17
EN 62368-1:2014 + A11:2017 & 60950-22:2017
CERTIFICATIONS
USA: FCC 90Y + 15C + 15E (UNII 15.247)
Canada: IC RSS 102 + RSS 111 + RSS 247
Europe: RED EN 301 489-1 + EN 301-489-17 + EN 300 328 + EN 301 893 + EN 302 502
Railway: EN 50155 + EN 50121 + EN 61373
PACKAGE CONTENTS  
  • One Tsunami® XP-10100-SUA unit with four N-type surge protected connectors
    Or One Tsunami® XP-10150-BS1/SUR unit with integrated 22 dBi panel antenna plus two N-type surge protected connectors
  • One power injector and country specific power cord
  • One Connector weatherproofing kit (Includes all recommended weatherproofing material)
  • One Wall / Pole mounting kit
  • One Grounding kit
  • Two 2.4 GHz, 5 dBi omni antennas
  • One Antenna alignment (RJ11) dongle
  • One Quick Installation Guide
MTBF and WARRANTY  
  >250 000 hours, 2-year warranty; ServPak Extended Support available.
ORDERING INFORMATION
XP-10150-BS1-WD Tsunami® XP 10150 Base Station, 866 Mbps, MIMO 2×2, 22 dBi panel antenna with 11n AP | Part Number : 901-00284
XP-10100-SUA-WD Tsunami® XP 10100 Subscriber Unit, 866 Mbps, MIMO 2×2, Type-N Connectors with 11n AP | Part Number : 901-00237
XP-10150-SUR-WD Tsunami® XP 10150 Subscriber Unit, 866 Mbps, MIMO 2×2, 22 dBi panel antenna with 11n AP | Part Number : 901-00285
 

¿Qué producto es adecuado para usted?