Multipoint 10250 BeamX Specifications

Descripción

 
INTERFACES
WIRED ETHERNET Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data)
WIRELESS PROTOCOL WORP® (Wireless Outdoor Router Protocol)
RADIO & TX SPECS
MIMO 2×2:2 and 0x2:2 (scan radio)
MODULATION OFDM with BPSK, QPSK, QAM16, QAM64, QAM256
FREQUENCY 4.900 – 5.850 GHz (Subject to Country Regulations)
CHANNEL SIZE 80 MHz, 40 MHz and 20 MHz
DATA RATE MCS 0 to 9 with Dynamic Data Rate Selection
TX POWER Up to 28 dBm (dual chain)
TX POWER CONTROL 0 – 27 dB, in 1 dB steps. Automatic TPC with configurable EIRP limit
  80 MHz 40 MHz 20 MHz Scan Radio
TX POWER (dual RF) MCS0: 28 MCS0: 28 MCS0: 29 N/A
MCS9: 21 MCS9: 22 MCS8: 25
RX SENSITIVITY (Per=10%) MCS0: -89 MCS0: -93 MCS0: -94 N/A
MCS9: -68 MCS9: -71 MCS8: -74
UDP THROUGHPUT Up to 672 Mbps Up to 324 Mbps Up to 137 Mbps N/A
OTHER Dynamic Channel Selection (DCS) based on interference detection
Dynamic Frequency Selection (DFS) based on radar signature
Automatic Transmit Power Control (ATPC) with EIRP limit support
ANTENNA
MP-10250-BSX
Integrated 2×2 MIMO Beam Steering antenna:
Beam Width 17° spanning over 60° sector
Receive Gain 16 dBi (11 dBi before 5.150 GHz)
Transmit Gain 20 dBi (11 dBi before 5.150 GHz )
MANAGEMENT
REMOTE Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3
SNMP SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
OTHER Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
Multi-Language Support Web Interface available in English, French, Spanish and Chinese
SYNCHRONIZATION
Pass-trough SyncE and Precision Time Protocol (IEEE 1588v2) Ethernet Synchronization
SECURITY
ENCRYPTION AES 128
AUTHENTICATION Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning)
QoS
Asymmetric Bandwidth Control Asymmetric UL/DL committed and maximum information rate per service flow
Packet Classification Capabilities 802.1p priority, IPTOS, VLAN ID, IP addresses, ports, Ethernet addresses, IP protocol, and EtherType
Scheduling Best Effort, Real Time Polling Services
NETWORK
MODES Bridging, Routing (RIP v2 and IP tunneling)
IP STACK IPv4 and IPv6 simultaneously
GATEWAY FEATURES DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS
VLAN 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
POWER
INPUT OUTPUT
36 to 57 VDC via Ethernet port1 (Power over Ethernet) 48 to 57 VDC – 25 Watt on Ethernet port2 (PoE – software controlled)
12 VDC via Access port 12 VDC on Access port
Power should not be provided simultaneously on both ports.  
POWER CONSUMPTION
30 Watt typical, 40 Watt maximum
ENVIRONMENTAL SPECS
TEMPERATURE OPERATING -40º to 60ºC (-40º to 140º Fahrenheit)
STORAGE -50º to 70ºC (-58º to 158º Fahrenheit)
HUMIDITY 100% relative humidity
IP RATING IP67
WIND LOADING 200 km/h (125 mph)
PHYSICAL SPECS
PRODUCT MODELS DIMENSIONS PACKAGED DIMENSIONS UNPACKAGED WEIGHT (PACKAGED) WEIGHT (UNPACKAGED)
MP-10250-BSX/SRX 18.46 x 7.05 x 21.57 in (469 x 179 x 548 mm) 14 x 14 x 3.40 in (371 x 371 x 85 mm) 13.67 lbs (6.2 kg) 7.27 lbs (3.3 kg)
SAFETY STANDARDS
IEC 62368-1:2016 & 60950-22:2016
UL 62368-1 2nd edition & 60950-22 2nd edition
CAN/CSA C22.2 No 62368-1:14 & No 60950-22:17
EN 62368-1:2014 + A11:2017 & 60950-22:2017
CERTIFICATIONS
USA: FCC 90Y + 15E (UNII 15.247)
Canada: IC RSS 102 + RSS 111 + RSS 247
Europe: RED EN 301 489-1 + EN 301-489-17 + EN 301 893 + EN 302 502
PACKAGE CONTENTS
  • One Tsunami® MP-10250-BSX/SRX with integrated BeamX antenna and scan radio
  • One power injector and country specific power cord
  • One Connector weatherproofing kit (Includes all recommended weatherproofing material)
  • One Wall / Pole mounting kit
  • One Antenna alignment (RJ11) dongle
  • One Grounding kit
  • One Quick Installation Guide
MTBF & WARRANTY
MTBF over 250 000 hours & 2-year warranty with ServPak Extended Support available.
ORDERING INFORMATION
MP-10250-BSX-US Tsunami® MP 10250 Base Station Unit, 867 Mbps, MIMO 2×2, 16 dBi BeamX antenna, scan radio | Part Number : 901-00291
MP-10250-BSX-WD Tsunami® MP 10250 Base Station Unit, 867 Mbps, MIMO 2×2, 16 dBi BeamX antenna, scan radio | Part Number : 901-00292
MP-10250-SRX-US Tsunami MP 10250 Subscriber Unit, 867 Mbps, MIMO 2×2, BeamX antenna, SmartScan radio | Part Number : 901-00340
MP-10250-SRX-WD Tsunami MP 10250 Subscriber Unit, 867 Mbps, MIMO 2×2, BeamX antenna, SmartScan radio | Part Number : 901-00341
LICENSE UPGRADES
MP-102×0-BSx-AES256-UPG Tsunami® MP 10200 Base Station, AES 128 to AES 256 license upgrade | Part Number : 997-00050
MP-102×0-SUx-AES256-UPG Tsunami® MP 10200 Subscriber Unit, AES 128 to AES 256 license upgrade | Part Number : 997-00049
 

¿Qué producto es adecuado para usted?